TSAUTOP Fully Automatic Hydro Dipping Machine V5.0
|Mode||3M fully automatic hydro dip machine|
|Overall Size||120*70*90(cm) / 3.94*2.3*2.79(ft)|
|Dipping Area Size||200* 110 * 70(cm)/ 2.62*1.97*2.3(ft)|
|Machine Material||Thickness = 2.5mm +- 0.2mm 201#Stainless Steel|
|Heating Elements||1 Set, 208 -240V, Single Phase, 50 HZ, 6000W|
|Water Cycle System||220V, Single Phase, 50 HZ, 750W|
|Automatic Spray System||130*35.2pcs spray guns, 400w servo motor for guns moving;750w for gun rack moving|
|Continuous Flow System||130*50*30，Power single /3 phases 220/380V 400w servo motor for film release;750w for film machine moving|
TSAUTOP Fully Automatic Hydro Dipping Machine For Rim
TSAUTOP Fully Automatic Hydro Dipping Machine is the smartest equipment that is used for Fully automatic water transfer printing, this equipment is fitted with an automatic constant temperature system, Automatic Activator Spray System, Automatic Film laying System, Automatic Dipping Arm, automatic water circle, automatic filtering system.
One person can operate this machine to finish the hydro dipping process, so it can save your human labor. TSAUTOP Fully Automatic Hydro Dipping Machine suits the medium dipping factory owner.
Step1.flushing water for clean—
Step 2. blowing the bubble of the water surface by air nozzle and divider—-
Step 3. laying the film on the water—
Step 4. film on the water for 25-35seconds—
Step 5. spraying activator on the film—
Step 6. dipping the products by dipping arm—
Step 7. putting out the products from the water—
Step 8. finish dipping—
Step 9. rinsing the products’ surface by the rinsing station.
The whole process will take 1.5-3minutes.
This machine has two models, one key automatic model, and separated manual operation for each system. Auto model: this model can continuously complete the whole dipping process including film flowing, activator spraying, dipping by a robot arm, and cleaning water by auto key button. All sizes and speeds can be set in PLC.
Manual model: operating the water pump, flow-film system, activator spraying system, dipping separately. And this model can check each device if it works well. All sizes and speeds can be set in PLC.
This machine can complete one dipping process in 3minutes, so it is very efficient. The flow-film system controlled by servo motor is very accurate, you can lay any length film as your requirement. So it will save your hydrographic film costs.
The Activator spraying system with 2 HVLP spray guns can be adjusted to be suitable for various films. The dipping arm powered by a 1.5kw servo motor is very stable and precise; this will ensure the quality of hydro dipping.
Heating function, 2sets 6000kw heating elements can heat the water quickly. The water temperature can be set at 25-30℃.
Water circle and filtering, the water pump power is 750w，it has strong flushing power and flushing over film dust will be filtered, instantly remove the remaining film dust, preparing for next putting film, and circle till the surface of water tank for maximum saving the water.