fully-automatic hydrographic dipping water transfer equipment

Fully-automatic Hydrographic Dipping Water Transfer Equipment

size(cm)Machine300*135*90 350*135*90 410*135*90
Dip Area200*110*70250*110*70310*110*70
Spary System130*35.   4 pcs spary guns
MaterialMachineThickness=2.0mm+-0.2mm 201#Stainless Steel
Dip Arm4*82mm thinckness aluminum alloy
PowerDip Armsingle /3 phases 220/380V 750W servo motor
Flow System130*50*30 ,  power signle /3 phases 220/380V 400w servo motor
Heat Elements2 set, 208-240V, single phase, 50HZ, 9000W
Water CircleStainless pump, 220V, single phase, 50HZ, 750WStainless pump, 208-240V, single phase, 50HZ, 750W
Gross WT800 KGS

The Instruction of TSAUTOP Fully Automatic Hydro Dipping Machine is one of our equipment which are used for Fully automatic water transfer printing equipment.

This equipment has automatic constant temperature system, Automatic Activator Spray System, Automatic Film Flowing System, Automatic Dipping Arm, water circle, automatic filter film dust features. One person can operate this machine to finish hydro dipping.

So it can save your human labor.


TSAUTOP Fully Automatic Hydro Dipping Machine suit for the medium dipping factory owner.

This machine has two models, one key automatic model and separated manual operation each system.

key automatic model and separated manual operation for hydrographic dip tankAuto model: this model can continuously complete the whole dipping process including film flowing , activator spraying , dipping by robot arm and cleaning by auto key button.

It is a highly efficient machine , which can complete the whole dipping in 3minutes.

All size and speed can be set in PLC.

PLC for fully automatic hydro dipping tank

Manual model: operating the water pump, flow-film system, activator spraying system, dipping separately.

All size and speed can be set in PLC.

This machine can complete one dipping in 3minutes, so it is very efficient.

The flow-film system controlled by servo motor is very accurate; it will save you film cost.

Activator spraying system can be adjusted to suitable for various film.

Dipping arm powered by servo motor is very stable and precise; this will ensure the quality of hydro dipping.

Heating function, 2sets 6000kw heating elements can start separately or all or not start, according to the weather hot or cold.

The water temperature can set 25-35℃.

Water circle and filtering, the water pump power are 750w, it has strong flushing power and flushing over film dust will be filtered, instantly remove the remaining film dust, preparing for next putting film, and circle till the surface of the water tank for maximum saving the water.

All in one, One machine +One person =One factory.

1. Full stainless steel outlook in high quality;

2. Fully automatic operation to save man labour;

3. Easy installation with modern design;

4. Low-noise, strong-flow, and long-life stainless-steel water pump;

5. One machine, one person and one dipping industry.

Pin It on Pinterest